Appleton HEX LED Series Exit and Emergency Egress Lighting For Unparalleled Safety and Reliability
Industrial facilities must have an Emergency, Escape, and Rescue (EER)
plan in place whose object is to ensure the safety of personnel during
an emergency. Among other requirements, the plan must include the
installation of bright, reliable emergency lighting for illuminating a
pathway to safety.
Lithonia Lighting
LEDs Have Things Looking Up for Downlights
Look up in most U.S. kitchens and you’ll likely see recessed downlights
shining back at you. These fixtures have been the go-to option for
decades – not just in kitchens, but throughout the house – for providing
area lighting that doesn’t interrupt a ceiling’s clean lines
Cree, Inc.
Lighting the Way to Better Health Outcomes
Keeping hospital balance sheets profitable is a challenging proposition
for healthcare organizations. That’s certainly one reason why so many
have undertaken lighting upgrades over the last decade to move to more
efficient LED lamps and fixtures.
advertisement
Lutron Electronics Co., Inc.
Harnessing Lighting: A Guide to Wireless Fixture Controls
In the constantly changing world of lighting technology, wireless
fixture control marks a significant leap forward. These systems, defined
by their ability to manipulate lighting conditions, without the need for hard-wiring,
are swiftly becoming a vital tool for electrical contractors and
lighting designers.
Duraguard Products Inc.
Sensing Opportunities: Pros and Cons of PIR and Microwave Approaches
Lighting the great outdoors requires a bit more thought now than it did a
couple decades ago. The goal used to be simply packing as many lumens
as possible into a landscape fixture. That was the entire point.
Photocell sensors might have been used to ensure lights didn’t stay on
during daylight hours, but keeping outdoor space fully illuminated –
even when no humans were around – was seen as a key safety measure.
Cooper Lighting
The Bright Future of 3-D Printed Light Fixtures
The concept of 3D printing, also known as additive manufacturing,
initially surfaced in the 1980s, thanks largely to the innovative work
of engineer Chuck Hull. Hull invented a process called
'stereolithography', or SLA, a method that allowed for the creation of
3D models layer by layer, literally bringing ideas to life. It was a
revolutionary breakthrough that sparked the beginning of the 3D printing
era.