Electrical Industry Articles and Stories

Lighting the great outdoors requires a bit more thought now than it did a couple decades ago. The goal used to be simply packing as many lumens as possible into a landscape fixture. That was the entire point. Photocell sensors might have been used to ensure lights didn’t stay on during daylight hours, but keeping outdoor space fully illuminated – even when no humans were around – was seen as a key safety measure.

The concept of 3D printing, also known as additive manufacturing, initially surfaced in the 1980s, thanks largely to the innovative work of engineer Chuck Hull. Hull invented a process called 'stereolithography', or SLA, a method that allowed for the creation of 3D models layer by layer, literally bringing ideas to life. It was a revolutionary breakthrough that sparked the beginning of the 3D printing era.

It’s hard to believe that it was just three years ago that much of the country was on red alert status thanks to Covid. Researchers were still learning more about the new virus, but one thing they were sure of was that it spread through the air, which made air purification systems a new priority for any place people gathered in large numbers.

Solar-powered exterior lighting has certainly gotten more popular over the last decade or so, given how inexpensive the fixtures are and how easy it is to install. But there remains a strong market for the hardwired variety in shady areas, where more powerful light is required and when you want to be sure the light works when you need it, even after a cloudy day.

Occupancy sensors are quickly becoming a regulatory requirement in many commercial spaces, thanks to evolving energy codes seeking to wring out kilowatt-hours of energy savings anywhere it’s possible.

The beauty of recessed can downlights is their seeming sleekness. They barely interrupt the ceiling plane, which can be an especially big bonus in homes with lower ceiling heights and in clean-lined contemporary room plans.